Order online now

EUR 168.98 EUR 142.00
Price incl. VAT Price excl. VAT
plus EUR 5.95 shipping costsplus EUR 5.00 shipping costs

Availability

Not in stock. We will obtain the article for you.

Estimated manufacturer's time of delivery: 30 days
updated: 17/11/2023

ETH8020 Ethernet Relay

Devantech

Overview

The ETH8020 provides 20 volt free contact relay outputs with a current rating of up to 16Amp each and 8 analogue inputs. The module is powered from a 12vdc supply which can be regulated or unregulated. The DC input jack is 2.1mm with positive core polarity, DC supplies are required to supply at least 1A at 12vdc. The relays are SPCO (Single Pole Change Over) types. The normally open, normally closed and common pins are all available on the screw terminals. The Relays on the ETH8020 can be controlled from the inputs on the ETH8020. This offers the opportunity to construct a system where an input can control an output anywhere on the earth provided both locations are connected to the network/internet.


Operating Temperature

-40°C to +70°C


LED indication

The ETH8020 provides a red LED mounted immediately next to each relay to indicate whether it is in a powered state (LED on), there is also two LED's mounted in the Ethernet connector which will flash with Ethernet traffic. Finally there is a red power LED alongside the screw terminals.


Relay power rating

If the contact load voltage and current of the relay are in the region enclosed by the solid and dotted lines in the figure below, the relay can perform stable switching operation. If the relay is used at a voltage or current exceeding this region, the life of the contacts may be significantly shortened.

 load type   Typical applications   Rating  Max DC load capacity

Relais Rating

 AC1  Non inductive or
 slightly inductive loads 
 16A @ 250V AC 
 AC15  Control of 
 electromagnetic load 
 (>72VA)
 3A @ 120V AC  
 1.5A @ 240V AC 
 AC3  Control of motor   750W
 DC1  Non inductive or
 slightly inductive loads
 16A @ 24V DC 
 DC13  Control of electromagnetic 
 loads
 0.22A @ 120V DC
 0.1A @ 250V DC

Control

The relay board communicates via TCP/IP and is controlled with a set of commands, which are sent to the board's IP-address on a configurable port. The commands are sequences of bytes, for example:
The sequence 0x20, 0x01, 0x32 will turn on relay number 1 for 5 seconds. A full specification can be found at the manufacturer's spec (see link below).

Newer firmware versions allow control via ASCII-commands and also a long requested feature of control via http. For example: Sending a http GET to
192.168.0.200/io.cgi?DOA1=10
sets relay 1 on active for 1 second (This would use the default address 192.168.0.200). You can test these functions by typing them directly into the address bar of most internet browsers. Also be aware that you may need to disable http authentication in the http configuration if your control device does not support it. A full specification and firmware updates can be found at the manufacturer's spec (see link 'Technical Specification' below).

Connections

DEV-ETH8020 Connections


Mapped inputs

Digital inputs of the ETH484, ETH484-B, ETH044, ETH8020 or WIFI484 are able to be configured to remotely control outputs on all of Devantech's new ethernet relay boards (both wired and WIFI), the older ETH-RLY02 and ETH-RLY16 are not compatible however. The mapped inputs offer simple linking and versatile usage, an input in one country can control a output in another, or across a small network.
Possible target boards are:


The independent inputs can be mapped to different relays (on the same or different boards). In the "Address of target board", you can enter an IP address or hostname (which will be converted to an IP address by the DNS server supplied in the board configuration). If the module is on the local network then you can use the assigned IP address, if the target is over the internet then you need to supply the gateway in the configuration (internet source IP like your router) and the "Address of target board" is the IP address of the targets internet connection (to point at the router).


Board dimensions

External dimensions of the ETH8020


IO Network - Android and iPhone App

Devantech created the free app 'IO network', available for Android and iPhone to remotely control your relays. Download it from Google Play or iTunes. Search for "Devantech" and you will find the app.

IO Network documentation for Android
IO Network documentation for iOS


Download

A full datasheet for the relays used on the ETH8020 is here.

PDF version of manufacturer's documentation: hier.


Manufacturer's data

Technical Specification - link to the manufacturer


Customer feedback

Voltage

Customer: "I want to use the ETH8020 with a battery up to 14.8 V if fully loaded."

Manufacturer: "The ETH8020 requires 12VDC, it will work at +/- 10% but 14.8V is starting to get too close to the 15V transient suppressor that is on the board."


Accessories

DEV-PA122521 12V universal mains adapter DEV-PA122521

DEV-PA122521 12V universal mains adapter

from ROBOT ELECTRONICS
Newest specification: 08/2019
EUR 17.98
plus EUR 5.95 shipping costs
Prices incl. VAT
EUR 15.11
plus EUR 5.00 shipping costs
Prices excl. VAT


Article no.: DEV-PA122521
More details...
ETH8020C - Ethernet Relais Modul Case DEV-ETH8020C

ETH8020C - Ethernet Relais Modul Case

from ROBOT ELECTRONICS
Newest specification: 12/2015
EUR 44.98
plus EUR 5.95 shipping costs
Prices incl. VAT
EUR 37.80
plus EUR 5.00 shipping costs
Prices excl. VAT


Article no.: DEV-ETH8020C
More details...

Product information for: ETH8020 - Ethernet Relay Modul

Publishing date (date of last technical specification): 2013-11-01
Length: 215 mm
Width: 123 mm
Weight: 500 g
Shipping weight: 600 g
Manufacturer: Devantech
Brand: ROBOT ELECTRONICS
Article number: DEV-ETH8020
Manufacturer's part number: ETH8020

The article ETH8020 - Ethernet Relay Modul is listed in the following categories:

Modules > Relay > Ethernet

dScript378 - 8 x 16A ethernet relay DEV-DS378

dScript378 - 8 x 16A ethernet relay

from ROBOT ELECTRONICS
Newest specification: 02/2017
EUR 100.98
plus EUR 5.95 shipping costs
Prices incl. VAT
EUR 84.86
plus EUR 5.00 shipping costs
Prices excl. VAT


Article no.: DEV-DS378
More details...
dScript2824 - 24 x 16A ethernet relay without snubbers - without snubbers DEV-DS2824

dScript2824 - 24 x 16A ethernet relay without snubbers

without snubbers (Variations available)
from ROBOT ELECTRONICS
Newest specification: 09/2016
EUR 168.98
plus EUR 5.95 shipping costs
Prices incl. VAT
EUR 142.00
plus EUR 5.00 shipping costs
Prices excl. VAT


Article no.: DEV-DS2824
More details...
ETH002 - Ethernet Relais Modul DEV-ETH002

ETH002 - Ethernet Relais Modul

from ROBOT ELECTRONICS
Newest specification: 11/2013
EUR 56.98
plus EUR 5.95 shipping costs
Prices incl. VAT
EUR 47.88
plus EUR 5.00 shipping costs
Prices excl. VAT


Article no.: DEV-ETH002
More details...
ETH8020 - Ethernet Relay Modul DEV-ETH8020

ETH8020 - Ethernet Relay Modul

from ROBOT ELECTRONICS
Newest specification: 11/2013
EUR 168.98
plus EUR 5.95 shipping costs
Prices incl. VAT
EUR 142.00
plus EUR 5.00 shipping costs
Prices excl. VAT


Article no.: DEV-ETH8020
More details...
dScript1242 - 2 x 16A ethernet relay DEV-DS1242

dScript1242 - 2 x 16A ethernet relay

from ROBOT ELECTRONICS
Newest specification: 05/2016
EUR 61.98
plus EUR 5.95 shipping costs
Prices incl. VAT
EUR 52.08
plus EUR 5.00 shipping costs
Prices excl. VAT


Article no.: DEV-DS1242
More details...
dScript3484 - 4 x 16A ethernet relay DEV-DS3484

dScript3484 - 4 x 16A ethernet relay

from ROBOT ELECTRONICS
Newest specification: 05/2016
EUR 85.98
plus EUR 5.95 shipping costs
Prices incl. VAT
EUR 72.25
plus EUR 5.00 shipping costs
Prices excl. VAT


Article no.: DEV-DS3484
More details...
ETH002-B - Ethernet Relay Modul DEV-ETH002-B

ETH002-B - Ethernet Relay Modul

from ROBOT ELECTRONICS
Newest specification: 01/2022
EUR 62.97
plus EUR 5.95 shipping costs
Prices incl. VAT
EUR 52.92
plus EUR 5.00 shipping costs
Prices excl. VAT


Article no.: DEV-ETH002-B
More details...
ETH008-B - Ethernet Relay Modul DEV-ETH008-B

ETH008-B - Ethernet Relay Modul

from ROBOT ELECTRONICS
Newest specification: 01/2022
EUR 88.98
plus EUR 5.95 shipping costs
Prices incl. VAT
EUR 74.77
plus EUR 5.00 shipping costs
Prices excl. VAT


Article no.: DEV-ETH008-B
More details...
ETH044 - 5Amp 4 Channel dimmable SSR module DEV-ETH044

ETH044 - 5Amp 4 Channel dimmable SSR module

from ROBOT ELECTRONICS
Newest specification: 02/2015
EUR 118.98
plus EUR 5.95 shipping costs
Prices incl. VAT
EUR 99.98
plus EUR 5.00 shipping costs
Prices excl. VAT


Article no.: DEV-ETH044
More details...
ETH0621 - 24v Motor controller and ethernet relay module DEV-ETH0621

ETH0621 - 24v Motor controller and ethernet relay module

from ROBOT ELECTRONICS
Newest specification: 02/2015
EUR 87.98
plus EUR 5.95 shipping costs
Prices incl. VAT
EUR 73.93
plus EUR 5.00 shipping costs
Prices excl. VAT


Article no.: DEV-ETH0621
More details...

Contact us

* These fields are mandatory.

Order online now

EUR 168.98 EUR 142.00
Price incl. VAT Price excl. VAT
plus EUR 5.95 shipping costsplus EUR 5.00 shipping costs

Availability

Not in stock. We will obtain the article for you.

Estimated manufacturer's time of delivery: 30 days
updated: 17/11/2023

Information on currency

EUR 168.98 = GBP 144.49 EUR 142.00 = GBP 121.42 (€1=GBP0.85505)
EUR 168.98 = USD 193.45 EUR 142.00 = USD 162.56 (€1=USD1.1448)
EUR 168.98 = CAD 243.60 EUR 142.00 = CAD 204.71 (€1=CAD1.4416)
EUR 168.98 = AUD 265.13 EUR 142.00 = AUD 222.80 (€1=AUD1.5690)

Share

About ROBOT ELECTRONICS

ROBOT ELECTRONICS is a brand by English manufacturer Devantech Ltd., based in Norfolk. Product range comprises sensors, in particular ultrasonic or compass, servocontrollers as well as small robot drive systems or relay modules with various interfaces. Sensors are produced in England and are of consistently high quality.

More from ROBOT ELECTRONICS